NAMED AFTER DANISH GUITARIST KNUD MØLLER

T-Rex Møller 2 delivers the same classic overdrive that made it's predecessor one of T-Rex’s most sought-after pedals. Named after Danish guitarist Knud Møller, for whom the original pedal was designed, Møller 2 features a more durable “Bass Boost” toggle switch and easier-to-read control knob graphics. The pedal is armed with a 0-20 db Clean Boost, as well as a Mix control which lets you dial in the perfect balance between distorted and clean signals. Rolled all the way up and with distortion maxed, the pedal sounds just like a vintage tube amp at full volume. Roll the Mix knob back a bit, and your clean signal starts to get through; if you pick lightly or roll back your guitar volume, you get a stunning clean, softly-clipping sound that retains all the feel and dynamics of your original tone, only bigger, louder and richer. The boost function lets you dial in a solo level, whether the overdrive circuit is activated or not.

CLASSIC OVERDRIVE WITH CLEAN BOOST

  • Classic bluesy overdrive
  • Provides a wealth of dynamic tones
  • Dial in the perfect balance between overdrive and clean signal
  • Independent clean boost for your solo
  • Stunning bluesy sound with just a little dirt around the edges
 

VIDEO

 

TECH SPECS

Input impedance @ 1KHz Higher than 1M Ohm
Output impedance @ 1KHz Lower than 1K Ohm
Power supply 9V DC (T-Rex FuelTank)
Minimum power supply voltage 8,5V DC
Maximum power supply voltage 12,5V DC
Current draw @ 9V DC 16 mA
Maximum input signal V p-p 2,5V p-p
Battery type 9V battery 6F22
Battery life 5-8 hours
External connectors input jack, output jack, 9V DC jack
Controls on/off, boost on/off, level, gain, tone, mix, bass boost
Pedal size incl. knobs (W x H x D) 100 x 55 x 120 mm / 3,9 x 2,2 x 4,7 inch
Weight excl. packaging 0,35 kg / 12,3 oz